UNITROL Accustart FOR SALE
IN-STOCK and Available Now from Weld Systems Integrators
Proper tip force is very important in the formation of a resistance weld.
UNITROL Accustart easily connects to the pressure switch input terminals on any brand resistance welding control.
When Tip Force is Too Low:
- Excessive Heat
- High Expulsion (sparks)
- Large Poor Looking Welds
- Drastic Reduction in Electrode Life
When Tip Force is Too High:
- Inadequate Heat
- Brittle Welds
- Limited Nugget Penetration
Tip Force should be reached before the 1st half cycle of weld current flows… and this Tip Force should not rise above the necessary force during the weld.
The UNITROL Accustart using the latest microcomputer technology contains a differential pressure transducer. As it subtracts back pressure from working pressure from the welder’s air cylinder, the effects of flow control or internal air cylinder leakage will be detected and prevent welding until proper TIP FORCE has been reached.
UNITROL Accustart Models:
|Model||Description||Dimensions – W x H x D|
|9580||Waits until differential air pressure equals value shown in the SET PRESSURE window of the system. At that time, a relay contact is closed to satisfy the PRESSURE SWITCH circuit in the existing welding control.||8″ x 3½” x 5″|
|9581||Waits until differential air pressure equals value shown in the SET PRESSURE window of the system. At that time, a relay contact is closed to satisfy the PRESSURE SWITCH circuit in the existing welding control. The unit also compares differential air pressure to the value shown in the HIGH LIMIT window of the system. If the pressure exceeds this value, a second relay contact closes for 1 second while an alarm sounds. Simultaneously, an indicator light glows and remains on until the next weld starts.||8″ x 3-1/3″ x 5″|
|9582||All the functions of the 9581 ACCUSTART plus a built in electronic AIR PRESSURE SETTING SYSTEM that automatically sets the pressure to match the value shown in the SET PRESSURE window. Unit comes complete with a remote 1/2″ air regulator and air pressure gauge.||11-1/2″ x 3-1/2″ x 5″|
- Voltage 115 VAC, 50/60 Hz (230 volts available at no additional charge)
- Relay contact rating 120 VAC @ .3 amperes, 30 VDC @ 1 ampere
- ACCUSTART comes complete with:
- 36 ” cable for connection to welding control
- keylock switch to prevent setting changes
- (2) 1/4″ poly tubing x 1/4″ NPT male fittings
- (1) 36″ long 1/4″ green poly tubing
- (1) 36″ long 1/4″ red poly tubing
- instruction/installation booklet
- Warranty – 1 year
Contact Weld Systems Integrators
CONTACT Weld Systems Integrators, or REQUEST A QUOTE on standard IN-STOCK inventory or fully custom welding equipment. To speak with a WSI team member, please give us a call at 844-WSI-WELD or +1-216-475-5629.